| Last Modified: 11-29-2007 | 1.6 G | |
| Service Category: Suspension | Section: Front Suspension | |
| Model Year: 2008 | Model: Sequoia | Doc ID: RM000001VPS00DX |
| Title: FRONT SUSPENSION: FRONT STABILIZER BAR: INSPECTION (2008 Sequoia) | ||
INSPECTION
1. INSPECT FRONT STABILIZER LINK ASSEMBLY LH
(a) Temporarily install the nut, and flip the ball joint stud back and forth 5 times as shown in the illustration.
(b) Use a torque wrench to turn the nut continuously at a rate of 2 to 3 seconds per turn. Take the torque reading on the fifth turn.
- Standard turning torque
Torque: 0.5 to 3.4 N·m (5.1 to 36 kgf·cm, 4.4 to 30 in·lbf)
If the value is not within the specified range, replace the front suspension toe control link with a new one.
(c) Check the dust boot for cracks or grease leakage.
|
|